奥钢联板坯铸机驱动力报警问题的分析及改进

浇铸过程中，驱动力报警会导致紧急停浇甚至滞坯事故发生。为防止事故发生，通常采用降速、强冷等措施，但降速造成成本浪费，强冷又产生裂纹等质量缺陷，两者都难以满足生产需要。通过对铸机的各项参数对比分析，找到影响驱动力报警的主要原因为辊缝异常，轻压下模型参数、冷却工艺设置不合理等，通过调整二冷工艺、优化模型参数、加强轻压下区域扇形段辊缝维护，可以达到明显降低驱动力、消除报警的目的，从而保证连铸生产稳定。     

配加蒙古精矿对球团矿性能的影响

对蒙古精矿在包钢624 m2带式球团的合理利用进行了全面研究。研究表明，随着蒙古精矿配比增加，球团矿品位提高，还原膨胀率增加，当配比小于20%时，还原膨胀率小于20.0%，主要是由于还原后球团矿矿物组成中析出大量金属铁，在浮氏体(FexO)转变为铁的阶段，铁晶粒自浮士体表面向外长出晶须，晶须的生长让晶粒产生位移或晶粒开裂，导致球团结构疏松发生膨胀。通过添加适量矽石，可显著降低球团还原膨胀率，当配加30%～50%的蒙古精矿时，可通过添加1.0%～2.0%的矽石，将球团还原膨胀率降低至20%以内，球团矿质量满足高炉冶炼生产要求。     

硫酸体系中锰钽铌矿加压浸出研究

针对单一硫酸体系锰钽铌矿加压浸出下钽铌浸出率均不到10%的问题,在硫酸体系引入助浸剂,考察氟化铵、双氧水、反应压强、硫酸浓度、反应温度、氟化铵矿比对锰钽铌矿加压浸出的影响,采用XRD对浸渣进行物相表征。实验结果表明,在锰钽铌矿加压浸出中,引入助浸剂氟化铵,温度200℃、硫酸浓度50%及氟化铵/矿比为0.8∶1的条件下钽浸出率超过93%,铌浸出率超过96%。引入氟化铵对硫酸体系下锰钽铌矿的加压浸出效果的提升十分显著。     

Microwave-assisted combustion synthesis of ZnAl2O4 and ZnO nanostructure particles for photocatalytic wastewater treatment

ZnAl₂O₄ and ZnO nanostructure particles and in situ crystallization of zinc aluminate and zinc oxide coating layers on sintered α-Al₂O₃ and γ-Al₂O₃ granules by the microwave-assisted combustion method were investigated. For powders, the effects of solution pH value and for coated samples the influence of support type on the structure, microstructure, and photocatalytic activity of powders were studied. Results showed that variation of synthesis pH value caused to considerable change in agglomeration, specific surface area, obtaining up to 88 and 92% yields for zinc aluminate and zinc oxide nanoparticles, respectively. γ-alumina granules were more appropriate supports than the α-alumina ones because of the better photocatalytic activities and lower extent of the attritions for both zinc aluminate and zinc oxide coating layers.     

Texture Feature Extraction Method for Ground Nephogram Based on Contourlet and the Power Spectrum Analysis Algorithm

It is important to extract texture feature from the ground-base cloud image for cloud type automatic detection. In this paper, a new method is presented to capture the contour edge, texture and geometric structure of cloud images by using Contourlet and the power spectrum analysis algorithm. More abundant texture information is extracted. Cloud images can be obtained a multiscale and multidirection decomposition. The coefficient matrix from Contourlet transform of ground nephogram is calculated. The energy, mean and variance characteristics calculated from coefficient matrix are composed of the feature information. The frequency information of the data series from the feature vector values is obtained by the power spectrum analysis. Then Support Vector Machines (SVM) classifier is used to classify according to the frequency information of the trend graph of data series. It is shown that altocumulus and stratus with different texture frequencies can be effectively recognized and further subdivided the types of clouds.     

A New NTRU-Type Public-Key Cryptosystem over the Binary Field

As the development of cloud computing and the convenience of wireless sensor netowrks, smart devices are widely used in daily life, but the security issues of the smart devices have not been well resolved. In this paper, we present a new NTRU-type public-key cryptosystem over the binary field. Specifically, the security of our scheme relies on the computational intractability of an unbalanced sparse polynomial ratio problem (DUSPR). Through theoretical analysis, we prove the correctness of our proposed cryptosystem. Furthermore, we implement our scheme using the NTL library, and conduct a group of experiments to evaluate the capabilities and consuming time of encryption and decryption. Our experiments result demonstrates that the NTRU-type public-key cryptosystem over the binary field is relatively practical and effective.     

Corrosion behavior of under‐, peak‐, and over‐aged 6063 alloy: A comparative study

The mechanical property of age‐hardenable Al‐alloys is governed by the state of ageing, which determines the microstructure and consequently, their corrosion behavior which is a vital aspect for a number of applications. This article presents a comparative assessment of corrosion behavior of under‐, peak‐ and over‐aged Al‐Mg‐Si alloy. Corrosion characteristics have been determined via immersion tests in 0.1 M ortho‐phosphoric acid solution and intergranular corrosion (IGC) tests. Corroded surfaces are examined by field emission scanning electron micrographs‐energy dispersive spectroscopy and 3D optical profilometer. The obtained results reveal that the corrosion rate at a specific immersion time as well as the depth of IGC increases in the order for under‐, peak‐, and over‐aged states. Irrespective of the state of ageing, corrosion loss increases linearly but the rate of corrosion decreases rapidly with increasing immersion time. The dominant mode of corrosion in under‐aged alloy is identified as localized pitting, while peak‐aged is highly susceptible to IGC in contrast extensive pitting corrosion is observed for over‐aged alloy. The observed differences in corrosion behavior are explained considering characteristics of precipitates. Formation of β (Mg₂Si) in case of over‐aged alloy and presence of inclusions like AlFeMnSi particles are found to accelerate pitting corrosion.     

提高加盖钢包自开率的研究与实践

首钢京唐300t钢包加盖后自开率明显下降，分析了加盖钢包自开率下降的机理，确定了主要原因是包衬温度升高后造成的液态渣回流。通过对引流砂的流动性、密度和渗钢性研究，设计了一种适用于加盖钢包的引流砂成分配比，并通过控制Al2O3和MgO含量，保证铬矿砂纯度。改进了钢包热修工艺，设计了针对加盖钢包的投砂操作和防钢渣回流措施。研究结果经推广使用后，钢包月不自开炉数由8～9炉降低至2炉以内，综合自开率达99.9%，双精炼工艺自开率达100%。     

负径向电场对带电粒子俘获率影响的数值模拟

本文采用数值方法求解Grad-Shafranov方程反演EAST典型长脉冲放电实验(炮号33068)的平衡位形和磁场分布，进而结合粒子在托卡马克电磁场中的运动方程，模拟氘离子在负径向电场存在时的运动轨迹，并统计不同负径向电场下的氘离子俘获率。结果表明：随负径向电场的增大，氘离子轨迹由扩张通行轨迹向外翻香蕉轨迹再向内翻香蕉轨迹，最后向压缩通行轨迹演变；氘离子俘获率随负径向电场的增大而减小，氘离子初始速度越小，其变化越大。     

On the capacity of the state‐dependent interference relay channel

This paper considers the state‐dependent interference relay channel (SIRC) in which one of the two users may operate as a secondary user and the relay has a noncausal access to the signals from both users. For discrete memoryless SIRC, we first establish the achievable rate region by carefully merging Han‐Kobayashi rate splitting encoding technique, superposition encoding, and Gelfand‐Pinsker encoding technique. Then, based on the achievable rate region that we derive, the capacity of the SIRC is established in many different scenarios including (a) the weak interference regime, (b) the strong interference regime, and (c) the very strong interference regime. This means that our capacity results contain all available known results in the literature. Next, the achievable rate region and the associated capacity results are also evaluated in the case of additive Gaussian noise. Additionally, many numerical examples are investigated to show the value of our theoretical derivations.